Simply replaces existing end cap on ISO grips.
Easy to install.
Screws supplied for use with or without ISO- Throttle Boss.
Supplied screws can accommodate only one accent ring.

Combining great style and comfort, these grips provide a soft, non-slip surface that dampens operating vibration.
Recessed area between the ISO-Pads permit air movement for added comfort in hot weather.

Combining great style and comfort, these grips provide a soft, non-slip surface with a knurled accent ring that adds a touch of class.

This grip is available for both 7/8" and 1" bars.
The stock throttle sleeve is re-used.
An easily cut spacer is included to accommodate bars of differing lengths.
Super hi-strength adhesive and easy step by step installation instructions are included.
NOTE: These grips are not compatible with "bar-end" weights found on many bikes. The majority of the time, removing these weights is a simple affair and the vibration absorbing quality of our ISO-Grips more than compensates for the vibration damping lost by removal of the "bar-end" weight . Sometimes, the "bar-end" weight is incorporated into the design of the stock grips and actually supports the end of the grips. Make sure removing "bar-end" weights will not affect the installation of the ISO Grips.